Try disconnecting the power and the back up battery, then press and hold the manual start / advance button for about 10 seconds to dissipate any residual power in the controller. Reconnect the power again to see if this has reset the controller.
How do I reset my Rainbird controller?
The current date and time will not be affected.
Turn the dial to Seasonal Adjust.Press and hold the left and right arrow buttons at the same time for at least 3 seconds. Until you see the word “CLEARED” on the screen.Turn the dial back to AUTO RUN. Your ESP-Me is now restored to the factory default settings.
Why is my Rain Bird sprinkler system not working?
✻ dirt or debris in case or nozzle ✻ foreign lubricants ✻ excessive water pressure ✻ inadequate water pressure Page 6 4 RAIN BIRD Common Problems The sprinkler is stuck or won’t return – The most common reason for this is water pressure that is too high or to low. Impact sprinklers can fail under either scenario.
How do I reprogram my Rainbird sprinkler system?
Rotate the dial to the “Watering start time” position and press the “+” or “-” keys to reprogram the time of day the watering cycle begins. Each zone will water in sequence starting at the time indicated. Programming multiple start times initiates the entire watering cycle again on the same day.
How do I reset my Rain Bird WiFi module?
Reset the WiFi module. While plugged in, press and hold the button on the WiFi module for 5 seconds. The LED should turn Amber colored, and then red, followed by three green blinks, followed by red and green alternating (WiFi Hotspot).
Why won’t my sprinklers turn on?
When the sprinkler zones do not turn on at all, it is generally a problem with the electrical signals running from the controller to the valve solenoids. More rarely, it is caused by a faulty valve that needs to be rebuilt or replaced.
Why does my sprinkler leak water when the system is turned off?
“Low Head Drainage” occurs when the lowest head on a zone allows water to drain from the lateral piping, out of the sprinkler. If it is low head drainage, residual water will stop flowing after all the water has left the pipe.
Why is my Rainbird running twice?
A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.
How do I connect Rain Bird controller to the Internet?
Launch the Rain Bird app and press the Add Controller button. Follow app prompts to set up WiFi connection to Rain Bird controller. Share access to the controller as needed. Program and test controller by turning on watering at the timer and through the Rain Bird app.
Why is my rain sensor flashing?
If the LED is flashing, the selected Transmitter location is within range. The rainfall setting determines the amount of rainfall needed to prevent your irrigation system from watering.
What is Rain Bird controller password?
The controller password is restricted to letters and numbers, 4-8 digits in length. No special characters. If you use a special character it will not be registered in the password. As an example, if you typed in 1234@, the password would be stored as 1234.
ncG1vNJzZmivp6x7or%2FKZp2oql2esaatjZympmeilravrsirm2aoomK8p7KMnJ%2Bem5titrV5zq6rZqCVp7JutM6wZJ2nXZ56s7HSnqtmpaliv6K1zZugq5xdmLyvwNGoo6WdomQ%3D